Decks
Custom pressure-treated, composite, and hardwood decks built to Oklahoma's structural and code requirements.
Spring and fall evenings in the Tulsa area and across the Cimarron Valley are genuinely pleasant. A properly built deck with good airflow makes summer evenings more manageable than you might expect. Oklahoma’s outdoor season is longer than most people give it credit for — the right deck takes real advantage of it.
Aero Precision builds custom decks for homeowners across Cleveland, Tulsa, Broken Arrow, Stillwater, Bartlesville, and Ponca City. We handle the permit process, structural engineering, and finish details — from the footing depth to the railing height requirements.
Building It to Last in Oklahoma
The biggest enemy of wood decks in this part of the state is the combination of summer heat, ground moisture, and the fungal and insect pressure that comes with both.
- Pressure-treated lumber must be the right specification for ground contact — 0.40 ACQ or better at all posts; generic treated lumber rated for above-ground use isn’t appropriate at soil contact points
- Post bases keep wood out of standing water, which is where rot starts
- Joist hangers at every joist — not toe-nailed, properly hangered with rated hardware
- Ledger attachment verified against the actual structural framing of the house, not just the siding
A deck ledger that fails takes part of the deck with it. We verify what we’re fastening to before the lag bolts go in. For covered decks that add a new roofline, we tie the structure cleanly into the house using the same flashing and framing standards we bring to our general construction projects.
Choosing Between Wood and Composite
Pressure-treated lumber is the cost-effective starting point. Built correctly, it lasts 25–40 years with periodic sealing. It will silver and check without maintenance, but a well-built treated deck is structurally sound for decades.
Capped composite decking — Trex, TimberTech, and similar full-wrap products — costs more upfront but requires essentially no refinishing and won’t splinter. Full-wrap boards resist moisture on all four sides, which matters in Oklahoma’s humid late summers. We carry both lines and can show you samples that won’t look like plastic from across the yard. See examples of our work in the project gallery.
A deck project is also a natural time to evaluate adjacent exterior work. If the back of the house has aging siding where the deck ledger attaches, we address it before fastening. If access has been restricted to a basement or crawl space, an attached deck is the right time to also look at spray foam encapsulation below.
If you’re thinking about a new deck in Cleveland, a replacement of an aging deck in Owasso, or a screened porch addition near Stillwater, get in touch and we’ll walk the space with you.
Our process
- 1
Site assessment and design
We walk the site, note grade changes and drainage, discuss how you'll use the space, and produce a scaled drawing with materials and dimensions.
- 2
Permit and footings
We pull the building permit, locate utilities, and dig and pour concrete footings to local frost depth and code-required bearing capacity.
- 3
Framing and decking
Beam and joist framing installed with proper hangers and hardware, decking laid and fastened to spec, then stairs, railings, and post caps completed.
- 4
Inspection and final finish
We schedule the required structural inspection, address any inspector notes, and complete any sealing or finishing specified in the project.
Materials & options
Pressure-Treated Lumber
Ground-contact rated ACQ or CA-treated southern yellow pine. The practical choice for Oklahoma's soil contact conditions and high-humidity summers.
Composite Decking (Capped)
Trex, TimberTech, and similar capped composite boards. Resists fading, staining, and splintering better than wood — low maintenance in the long run.
Hardwood Decking
Ipe, Cumaru, and similar tropical hardwoods. Dense enough to resist rot without treatment, naturally resistant to insects. Higher upfront cost, longer service life.
Aluminum Decking
Hollow aluminum deck boards that never rot, warp, or need refinishing. Good choice for covered decks and screened porches where moisture is concentrated.